#Apricorn sata wire not recognized drivers

Once the RAID has been configured you can shut down the PC and move the DUO to the MacPro. Once completed Save the configuration and exit the BIOS. Use the arrow keys to change your RAID type. Once in the BIOS use the Enter key to start the configuration wizard. Boot the PC and when you see the Marvell BIOS displayed youВ’ll hit Control M to enter the BIOS of the Marvell chipset (on the Velocity Duo) They should be brand new, or recently zeroed. They should be identical drives with matching firmware. Mount the two drives you want to use on the card. Here are the steps you would need to follow. The EFI bios in the MacPro does not support this feature. Unfortunately, the RAID will need to be configured with the card mounted in a PC with a BIOS that can be accessed during boot time. The Velocity can be configured as a hardware RAID 0 and used in the MacPro. I just put it all back together and so far all seems to be well.Дuo X2 does have Hardware RAID capability It thankfully ran right off with no problems. I rebooted into Windows 8, then rebooted back to OS X using the normal process.

Next I simply mounted both SSDs on the Velocity DUO x2, installed it, and it booted OS X right off. But swapping slots fixed that enough to get things working.) (I did have some strange boot issues with both cards in the computer at the same time and which PCIe slot had which card.

#Apricorn sata wire not recognized drivers

I booted the existing Windows 8 configuration with the Velocity DUO card installed in the system so that Windows would load any new drivers it required for the new card. I added the recovery partition as part of the clone with CCC. I had that SSD mounted in a drive bay, and I made sure it booted and ran OK after cloning. I cloned the RAID-0 image to a single 840EVO 1TB SSD to prepare that for the Velocity DUO card. I already was running with OS X on a RAID-0 SSD array with a Tempo Pro SSD PCIe card and Windows 8 SSD on a Velocity Solo x2 PCIe card.